| www.iFourWinns.com https://smwebhead.com/phpBB3/ |
|
| Bleeding power steering https://smwebhead.com/phpBB3/viewtopic.php?f=13&t=12921 |
Page 1 of 1 |
| Author: | Serial Wakest [ Thu May 22, 2014 7:07 am ] |
| Post subject: | Bleeding power steering |
After going through my new used 88 horizon 4.3 2 barrel, I found a loose power steering line. It was 1/3 of a quart low. I just got the boat running with no power steering. Before pointing the finger at the pump, is their a method to bleed the lines or pump? |
|
| Author: | rpengr [ Thu May 22, 2014 3:10 pm ] |
| Post subject: | Re: Bleeding power steering |
As far as I know, you just steer all the way lock to lock a few times. There may be some bubbles remaining after that, so just repeat the procedure on the next engine start-up. Ray |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|