www.iFourWinns.com
https://smwebhead.com/phpBB3/

Drum to disc conversion.
https://smwebhead.com/phpBB3/viewtopic.php?f=12&t=7457		 Page 1 of 1
Author:  ridepate [ Wed May 11, 2011 6:46 pm ]
Post subject:  Drum to disc conversion.
Finally got my parts. Got the rotating-asemblies installed today. Gonna get after the actuator tomorrow.

Image


Image
Author:  PDACPA [ Thu May 12, 2011 10:22 am ]
Post subject:  Re: Drum to disc conversion.
Did you put in new leaf springs or just paint the originals? I just cut off my old rusted disc brakes and researching their replacements. Looking forward to see more of your progress.
Author:  Paul I. [ Thu May 12, 2011 1:00 pm ]
Post subject:  Re: Drum to disc conversion.
Easy to do, just a pain. You may need to change the actuator out too. The one on my trailer is only for disc not drum brakes.
Author:  ridepate [ Thu May 12, 2011 3:17 pm ]
Post subject:  Re: Drum to disc conversion.
PDACPA wrote:
Did you put in new leaf springs or just paint the originals? I just cut off my old rusted disc brakes and researching their replacements. Looking forward to see more of your progress.



I just coated the leaves with some rubberized-coating I had laying around.
Author:  ridepate [ Sun May 15, 2011 11:13 pm ]
Post subject:  Re: Drum to disc conversion.
Road-tested the Kodiak discs today. Awesome!!!!!!!!! There was no boat behind me anymore!!! Just wish the boat would have cooperated...................
Author:  LouC [ Mon May 16, 2011 12:51 am ]
Post subject:  Re: Drum to disc conversion.
When I put on a new set of springs, I coat em in marine grease and then spray em with Boeshield or Corrosion X HD every season, I have not had rusting problems even in salt water.
I might do disc brakes if I ever up grade my trailer axle...
Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/