| www.iFourWinns.com https://smwebhead.com/phpBB3/ |
|
| COTTER PIN QUESTION https://smwebhead.com/phpBB3/viewtopic.php?f=11&t=23888 |
Page 1 of 1 |
| Author: | mark1190 [ Sat Jul 12, 2025 7:06 pm ] |
| Post subject: | COTTER PIN QUESTION |
The cotter pin holding my prop assembly has only one bent pin. (See pic) Is that normal? Did one side break off? Should there be two? Am I risking having it all fall apart? Replacing easy enough, I suppose. Any idea of the size or would any pin that fits work? UPDATE: NEVER MIND - I tested the integrity of the pin by tugging on the hub and the remaining pin cracked. So I removed it and replaced it with a 1/8th x 1.5 inch STEEL cotter pin. They didn't have stainless. When I find a stainless I will replace it again. Thanks, team! Mark Portland, OR |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|